EXCELL PRECISION CO., LTD
02005302 ZSME300000237 31
Press
UNITS
key
Chapter 3 Service Mode Access
Set the switch SWA1 on the bottom of machine to the ADJ position. Switch the machine on.
The display shows
.
When finished, set the switch SWA1 back to the LOCK position.
If the switch SWA1 is returned to the LOCK position during calibration, the scale exits the
service mode automatically.
⇒ Capacity Setup ⇒ Function Setting
⇒ Weighing Calibration ⇒ Local Gravity Setting
⇒ Linearity Calibration
Press
ON/ZERO
key Press
UNITS
key
Press
ON/ZERO
key
Press
ON/ZERO
key
Press
ON/ZERO
key
Press
ON/ZERO
key
Press
UNITS
key
Press
UNITS
key
Press
UNITS
key
To Next Page
Loading...
Need help?
General
