--------------------------------------------------------------------------
Chap 3 System programming
The system has the initialize settings when left factory, user can use it normally when
installed and connected well, don’t need refer this chapter; if user want to change some settings,
that should be refer this chapter.
3.1 Before programming
●Trunks mean telephone line from local ISP, connect with the PABX port C01-C04, also called
C.O.Lines; User Lines mean the line which connect with the PABX port 601-616, also called
internal line, the connected telephone called extension.
●All the extensions must be of dual tone multi-frequency phone. All the programming must be
carried out on the extension 601, 602, 603, 604; all the programming must be into system
programming status.
●When the setting is finished, a long beep indicates that the setting is done correctly and
saved in the system. If instead an array of short chirps is heard, that would indicate an error
occurred in the setting. You need to check it out and reset the system. It is only after the end
of the long beeps you can continue another system operation.
●You are allowed to operate one by one, and end the process by simply pressing #. You don’t
have to hang up if something wrong occurs, you could press * to restart.
●If programming-extension (601,602,603,604) is in Direct-Dialing-Out mode, you need to
press * to enter the internal system, then start programming.
●You must use “enable C.O. lines” command according the actual trunk lines before using
this product, if you don’t enable any C.O. line, the system will consider there is no C.O. line
and doesn’t auto detect C.O. line.
●The functions which is optional in this user manual, that mean just some models have the
function, please be sure your model and then can know if your machine has that functions.
●CS308/TS308 are the same programming format with CS416/TS416, just the C.O.line port
and extensions port are different.
How to programming
At first you must according 3.2.1 instruction enter into system programming status, and then
you can begin to program as the following instruction.
To Next Page
Loading...
