--------------------------------------------------------------------------
3.2.4 Flash time setting
Format: 0 0 L #
L=1 ---------0.8s L=2 ---------1.0s L=3 ---------1.2s L=4 ---------1.5s L=5 ---------1.8s
Explanation: L means the flash time grade.
Description: For active the hold and divert operating use.
In default setting: L=2 (1.0s)
Example: Set the flash time to 1.2S,then in programming status input 003#,hear du is ok.
3.2.5 System return to default setting
Format: 0 0 0 0 #
Description: when returning to default setting, please wait and hear the confirm sound that means
ok. Default setting please see the Chapter 8. This action will not effect the data of the charging.
1. this format can not return the flexible code extension number, also can not effect the
C.O. lines opening and shutting (refer to 3.3).
2. If want to return the extension number default setting, input 9000#
3.2.6 Setting Delay time for outgoing call transfer
Format: 0 3 T T #
Description: T=01-99, unit is second; this time mean the time which is from finish dialing the last
number to the system start to charge. The system restriction time also from this time,
and also allow system transfer function.
Default setting: Duration of time-delay being 5 seconds.
Example: Setting delay time: 8s, then input 0 3 0 8# in programming status.
3.3 Enable/Disable C.O. Lines
You must use these commands according the actual trunk lines before using this
product!!! If you don’t enable any C.O. line, the system will consider there is no C.O. line and
doesn’t auto detect C.O. line!!!
3.3.1 Enable C.O. Lines
Format: 0600#
Description: Enable all C.O. lines
To Next Page
Loading...
