--------------------------------------------------------------------------
Chap 4 Operating Instruction
Important Note ：1、If the Ext. is in indirect-dialing-out mode(refer 3.9), no need
to dial * which is in [ ] in following operation.
In examples we suppose the Ext. is in indirect-dialing-out
mode if don’t explain specially.
2、Programming Extensions include Ext. 601, 602, 603, 604 .
4.1 Answering calls at operator mode
The Extensions which is set to be operator mode ringing extension will ring when an incoming call
is received, and pick up the handset you may answer the call directly. Under the default mode,
Ext601 and Ext602 will ring.
4.2 Answering calls at auto-attendant mode
The system use one paragraph of OGM messages, the relevant messages will be heard automatically
when a exterior caller call the C.O. line.
When a caller dials “0” for inquiry, operator extension will ring.
4.3 Day/Night Mode Manual Setting
This system has one way to switch Day/Night mode: manual mode, you can input the following
command:
Format: [*] # 2 0 # Switch the system to day mode.
[*] # 2 1 # Switch the system to night mode.
1、The default mode is day mode.
2、The command can be inputted only by Programming Extensions ( Ext. 601, 602, 603,
604 and the operator) , not in programming mode.
3、[*] means If the Ext. is in indirect-dialing-out mode, no need to dial *( only dial #20# or
#21#),while the Ext. is in direct-dialing-out mode, need to dial *(should dial *#20# or
*#21#) .
NOTE: In Manual mode, you are needed to switch Day/Night mode through setting manually, that
means every day you must set manually if you want switch Day/Night mode. The system will be in
Day mode always (or Night mode) if you don’t set manually.
To Next Page
Loading...
