Remote Control Commands
106 FVA-3100
Specific commands-Quick Reference Command Tree
OUTPut[:STATe]
Description This command controls the shutter, which can block optical
continuity.
Syntax OUTP[:STAT]<wsp><boolean>
Parameters The <boolean> parameter can be
“0” or “OFF” to optically close the shutter
“1” or “ON” to optically open the shutter
Example OUTP:STAT ON
Note This command cannot be issued while a program is running.
The OUTP:STAT command is similar to the D command.
OUTPut[:STATe]?
Description This query returns the state of the shutter.
Syntax OUTP[:STAT]?
Response “0” if the shutter is optically closed
“1” if the shutter is optically open
Example OUTP:STAT?
Note The OUTP:STAT? command is similar to the D? command.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
