Variable Attenuator 11
3 Getting Started With Your
Variable Attenuator
Installing your FVA-3100 Variable Attenuator
in a Rackmount
You can place your FVA-3100 Variable Attenuator in a rackmount in order to
facilitate its usage.
To install the rackmount:
1. Fix the angle iron using four flat Phillips screws.
2. Fix the rackmount bracket to the frame using two round Phillips
screws.
3. Fix the rackmount stiffener using two flat Phillips screws (for the front
panel) and two round Phillips screws.
4. If your rackmount will have only one position, fix the rackmount cover
plate to the frame using four flat Phillips screws.
2
3
4
1
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
