Variable Attenuator 81
B Remote Control Commands
IEEE 488.2 Required Commands
The Variable Attenuator recognizes the main commands identified in
IEEE-488.2. These commands are fully explained on the following pages.
.
The commands are fully explained in the following pages.
Command Function
*CLS Clear status command
*ESE Standard event status enable command
*ESE? Standard event status enable query
*ESR? Standard event status register query
*IDN? Identification query
*OPC Operation complete command
*OPC? Operation complete query
*RST Reset command
*SRE Service request enable command
*SRE? Service request enable query
*STB? Read status byte query
*TRG Trigger command
*TST? Self-test query
*WAI Wait to continue command
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
