AvediaStream e2635/e3635 and e2655/e3655 Encoders V1.1
Administrator’s Guide 29
Remote logging
To send device log information to a remote server, you need to install a syslog server
application on the remote server. Then set up the remote logging function on the encoder as
described below.
To configure remote logging:
1. Click Logging.
2. Select Local and Remote from the Logging drop down list.
3. In the Syslog server field, enter the IP address or host name of the syslog server where
the log files are to be stored.
4. In the Syslog port field, enter the port number on the syslog server. The default value is
514.
5. Click the Logging level drop down list and select an option ranging from 0-Emergency to
7-Debug, where 0 represents the least debug information and 7 represents the most.
6. Click the Apply button.
Time server
The encoder uses NTP to maintain accurate time on the device, using the time server
specified. This is useful when examining the device log file as accurate time information will be
attached to log messages.
If a time server is supplied to the device by the DHCP server, this will be used if the
administrator has not already specified a time server.
To specify a time server:
1. Click Maintenance.
2. Enter the IP address or the host name of the time server in the Time Server field.
3. Click the Apply button.
To Next Page
Loading...