EasyManua.ls Logo

Exterity AvediaStream e2535 - EU and Others Safety; General Safety Information

Exterity AvediaStream e2535
57 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
AvediaStream e2535/e3635 and e2655/e3655 Encoders V1.1
Administrator’s Guide 5
13. Unplug this apparatus during lightning storms or when unused for long periods of time.
14. Refer all servicing to qualified service personnel. Servicing is required when the apparatus
has been damaged in any way, such as power-supply cord or plug is damaged, liquid has
been spilled or objects have fallen into the apparatus, the apparatus has been exposed to
rain or moisture, does not operate normally, or has been dropped.
15. Do not expose this apparatus to dripping or splashing and ensure that no objects filled with
liquids, such as vases, are placed on the apparatus.
16. To completely disconnect this apparatus from the AC Mains, disconnect the power supply
cord plug from the AC receptacle.
17. The mains plug of the power supply cord shall remain readily operable.
WARNING: To reduce the risk of fire or electric shock, do not expose this apparatus to rain or
moisture.
EU and Others
Do not proceed beyond a WARNING! notice until you have understood the hazardous
conditions and have taken appropriate steps.
Safety Information
WARNING! There are no user serviceable parts inside any Exterity product. To prevent
electric shock or fire hazard, do not remove cover. Refer service to qualified service personnel.
WARNING! For 230/240 volt operation, be sure to use a harmonised grounded 3 conductor
cord, rated 6 Amp minimum. Use a suitable cord for connection to the equipment and
terminating in an IEC approved plug.
This equipment relies upon a safety earth for operation, ensure that you always use a power
cord with appropriate earth and that the inlet to which is inserted also has the appropriate
earth. If in any doubt about the earth provision in your building consult a qualified electrician
WARNING! Use only the dedicated power supply or cord supplied for your device.
WARNING! The Exterity products use ventilation holes for cooling. None of the ventilation
holes should be blocked. Keep all materials at least 5cm away from all the ventilation holes.
WARNING! Do not expose the product to any rain or moisture.
WARNING! Do not use the product near a naked flame e.g. a candle.
WARNING! The operating conditions of the product should be 0°C-40°C with a Relative
Humidity of 5 95%.The product should not be operated outside of these conditions.
There are no user-serviceable parts inside these products. Any servicing, adjustment,
maintenance, or repair must only be performed by service-trained personnel.