AvediaStream e2535/e3635 and e2655/e3655 Encoders V1.1
Administrator’s Guide 9
How this Manual is Organised
This manual is organised as follows:
Chapter 1 – Getting Started
This chapter describes how to get the
encoder up and running.
Chapter 2 – Physical Interfaces
This chapter describes how to connect your
AV equipment to the encoder.
Chapter 3 – Management Interfaces
This chapter describes the management
interfaces you can use to manage the
encoder: the IPTV Manager, Web
Management Interface and admin interface.
Chapter 4 - General Device Management
This chapter describes general configuration
of the encoder. For example, IP address
configuration and the firmware upgrade
procedure are explained here.
Chapter 5 – Admin Interface
This chapter describes how to configure the
encoder using the serial Admin Interface.
Chapter 6 - Encoding and Streaming
This chapter explains how to configure the
encoder to take accept the input of the AV
source and convert this into an IPTV stream.
Chapter 7 - Status Monitoring
This chapter explains how to check the
operating status of the encoder.
Chapter 8 – Troubleshooting
This section provides troubleshooting
information if you are having problems with
the encoder.
To Next Page
Loading...