Extraflame Comfort Maxi - 16 Displays

DISPLAYS
26
DISPLAYS16.
Display Reason Solution
IGNITION The ignition phase is in progress -
STARTUP The start phase is in progress -
COOLING STAND
BY
A new ignition is attempted when the
stove has just been switched-o
When the stove switches o , it is necessary to wait until complete
fumes motor switch o and then clean the burn pot.
The stove can only be re-ignited when these operations have been
performed.
COOL. STDBY
BLACK OUT
The stove is cooling due to black out On completion of the cooling phase, it will re-ignite automatically.
PELLET FEEDING
The feeding of the pellet during the ignition phase is in progress
HOT
Set room thermostat set at maximum
value.
The stove works at set start, without ever modulating. To escape this
function just lower the set temperature using key 2.
WORK The normal work phase is in progress -
LOW
Room thermostat set at minimum
value.
In this way the stove only works at 1st power independently from the
power set. To escape this function just raise the room temperature
using button 3.
MODULATION The stove is modulating -
STAND BY
Stove o due to temperature reached
and in stand-by for re-ignition.
To deactivate the STAND-BY function see the speci c chapter.
STAND BY EXT
Stove o due to an external thermostat,
waiting for re-ignition
To deactivate the STAND-BY function see the speci c chapter.
START The start phase is in progress -
BURN POT
CLEANING
The automatic burn pot cleaning is in
progress.
The automatic burn pot cleaning (not in 1st power) is performed at
pre-established intervals of continued working.
FINAL CLEANING When the stove is switched-o ,  nal cleaning is in progress. The  nal cleaning phase lasts about 10 minutes.