CHAPTER G G - 8
other executable bits set, it is scanned regardless of the file
extension.
--scantimeout=value
Set a time limit in seconds for a single file scan or disinfection
task. If scanning or disinfecting the file takes longer than the
specified value, fsav reports a scan error for the file.
If the value is set to 0 (default), the scan timeout is disabled and
the file is scanned until the scan finishes (or a scan error occurs).
--short[={on,off,yes,no,1,0}]
Use the short output format. Only the path to infected or
renamed files is shown.
--shutdown
By default, fsavd does not immediately exit after completing a file
scan but hangs around waiting for new scan tasks. This option
can be used to make an idle fsavd exit immediately.
--silent[={on,off,yes,no,1,0}]
Do not generate any output (except error messages).
--socketname=socket path
Use the given socket path to communicate with fsavd. The
default socket path is /tmp/.fsav-<UID>, or /tmp/.fsav-
<UID>-sa, if fsav is started with the --standalone option.
--status
To Next Page
Loading...