FAAC B614 - Page 24

1920
18
B614 22 532297 - Rev.D
2
2
21
1
3
6
5
5. (18) Insert arm 1 in the lever.
!
To make the insertion of the arm easier, rest it on a
stand at the other end.
6. Line up the two holes underneath (slide the lower
edging temporarily to uncover the holes).
7. Fix the arm with screws 2 and relative washers
(reposition the lower rubber edge).
8. (19) Insert cover 1 and secure it it with screw 2
and relative washer.
9. Insert the cover 3 at the end of the arm.
!
Leave the arm supported to take the weight until
the installation of the spring is complete (20).