29
B614 28 532297 - Rev.D
2
1
4.11 INSTALLING THE TOP COVER
If there is a flashing light kit, insert the connector
before closing the cover (see the chapter § 8).
1. (29) With the cover inclined, insert tabs 1 in
slots 2 on the box (arm side), then lower it on the
opposite side.
2. Close with the key: turn anticlockwise.
3. Check that the cover is secured: try to lift it from
both ends at the same time and then on the
opposite side.
For the seal to be effective, The door of the barrier
must be closed completely.
To Next Page
Loading...
