FAAC B614 - Limits Adjustment

26
B614 26 532297 - Rev.D
6
15 Nm
2
13
1
1
2
2
1
A
B
3
3
4.8 LIMITS ADJUSTMENT
The gearmotor is supplied with the limits already
adjusted.
It is possible to work on the limits to fine tune the arm’s
horizontal and verticality positions (26).
Limit A Limit B
RH barrier vertical arm horizontal arm
LH barrier horizontal arm vertical arm
!
This operation requires the release of the barrier.
- Release the barrier using the manual release key when
there is no electrical power.
- Keep away from the moving elements inside the
box and from the coil spires.
- Do not leave the arm vertical when the barrier
is unlocked.
1. At the same time, loosen lock nut 1 and the screw 2.
2. Keep the lock nut 1 still and manually adjust the
stop with screw 3.
3. Tighten the lock nut 1 with the hex wrench and the
screw with Allen key 2.
4. Check the correct adjustment of the limits. Repeat
the sequence if necessary. At the end, tighten
screw 2 completely with the indicated torque.
!
Use the torque wrench to tighten to the torque shown
in the figure.