FAAC B614 - Single Spring; Double Spring

23 24
B614 24 532297 - Rev.D
2
1
SINGLE SPRING
1. Lengthen the turnbuckle by manually unscrewing
it to facilitate the operation.
2. (23) Hook the spring onto the turnbuckle and
the appropriate slot at the bottom of the barrier
body (see  2).
3. Shorten the turnbuckle by rotating it manually to
place the spring under tension.
!
Keep away from the spring coils.
DOUBLE SPRING
1. Lengthen the turnbuckle by manually unscrewing
it to facilitate the operation.
2. Lower bracket (24): Connect the plate 1 to the
slot on the base of the barrier body as shown in
the figure and lock it in position using the part 2.
Attach the 2 springs.
3. Upper bracket (24): Attach the plate 2 to the
springs and then to the turnbuckle.
4. Shorten the turnbuckle by rotating it manually to
place the spring under tension.
!
Keep away from the spring coils.