Working in CSS (constant surface speed) mode.
To select the cutting (surface) speed, press:
To select the maximum turning speed, press:
+ Cutting (surface) speed
+
+ + Cutting (surface) speed
+
Working in RPM mode (revolutions per minute).
To select the turning speed, press:
The CNC displays the following information.
+ Speed +
Selected speed.
Percentage applied.
Turning direction.
Active spindle range (gear).
Selected speed.
Turning direction and percentage applied.
Maximum turning speed.
Active spindle range (gear).
A work gear (range) must be selected before programming
the cutting speed. A gear change cannot be done during a
machining operation.
The CNC assumes by default the active gear. Once the gear
has been chosen, go into CSS mode.
To Next Page
Loading...
