Self-teaching manual
94
·TC· Option
CONVERSATIONAL PART PROGRAMS.
6
- - CREATING A NEW PART - -
111 - THREADED AXIS
122 - TAPER AXIS
333 -
444 -
555 - EXAMPLE
Select the program with the focus.
PART - PROGRAMS CYCLES
Select an operation and define
its parameters. When the
operation is defined, press
[P.PROG].
- - CREATING A NEW PART - -
111 - THREADED AXIS
122 - TAPER AXIS
333 -
444 -
555 - EXAMPLE
PART - PROGRAMS CYCLES
1 - TAPER TURNING CYCLE 1
Repeat these steps for the other
operations. In this case, the
part-program will be as follows.
- - CREATING A NEW PART - -
111 - THREADED AXIS
122 - TAPER AXIS
333 -
444 -
555 - EXAMPLE
PART - PROGRAMS CYCLES
1 - TAPER TURNING CYCLE 1
2 - ROUNDING CYCLE 1
3 - TURNING CYCLE
To Next Page
Loading...
