Fargo DTC4250e - Page 92

DTC1000Me-1250e-4250e-4500e Card Printer Service Manual PLT-01543 rev 1.0
November 2013 92
.
Step
Procedure
5
With the Mainboard loosened and tilted back the wire connections are now accessible.
Locate the Lamination Head Assembly wire connections.
Remove these wires from the mainboard.
Location of Upper Lam Head Cables
Lift Sensor D920156 connects to J4
Heater Cartridge D920113 connects to J9
RTD Cable D920151 connects to J18
Location of Lower Lam Head Cables
Lift Sensor D920156) connects to J21
RTD Sensor Cable D920151 connects to J17
Heater Cartridge Cable D920113 connects to J3
6
Remove the Lamination Module assembly.
Replace with new Lamination Module assembly using reverse assembly procedure.
7
Make NOTE: of how the wires are routed. UPPER ASSEMBLY
(continued next page)