Chapter 6 Description of Operations
PAGE 6-46
D-No.200 controller Setup Tool No. Setting range: Tool No. registered for the model
The Tool No. of the connected tool is set with reference to “Tool Models.” When the unit setup
tool No. is changed, initialization and automatic correction of the fastening parameter set values are
performed.
D-No.201 controller Setup Tool Information
The maximum torque and motor capacity of the tool of D-No. 200 “controller Setup Tool No.” are
indicated.
D-No.202 Parameter Setting File Version
The version of the parameter file set in the controller is indicated.
D-No.203 Sequence Setting File Version
The version of the sequence file set in the controller is indicated.
D-No.204 PLC Output Layout Setting File Version
The version of the PLC output layout file set in the controller is indicated.
D-No.205 Fieldbus Setting File Version
The version of the fieldbus file set in the controller is indicated.
D-No.206 Fieldbus Message Setting File Version
The version of the fieldbus message file set in the controller is indicated.
D-No.207 RS232C Input/Output Setting File Version
The version of the RS232C input/output file set in the controller is indicated.
D-No.208 controller RS232C-1 Communication Speed [bps]
The communication speed of the RS232C-1 interface is indicated.
D-No.209 controller RS232C-1 Parity
The parity of the RS232C-1 interface is indicated.
D-No.210 controller RS232C-1 Stop Bit [bit]
The stop bit of the RS232C-1 interface is indicated.
D-No.211 controller RS232C-1 Data Length [bit]
The data length of the RS232C-1 interface is indicated.
To Next Page
Loading...
