Chapter 3 Part Names
PAGE 3-3
3-1-2 controller Rear Panel
Note : * FIELDBUS, CF card, RS232C-2 and Data report ethernet are optional.
Please do not change it AXIS ADDRESS(01)、SW1(1,2,7,8 ON)、SW2(ALL OFF).
T/A MON.
Connector for torque and angle
monitor output connection.
(PAGE 4-18)
RS232C-1
Connector for output of fastening
result data.
Can be connected to a PLC, printer,
PC, etc. (PAGE 4-19).
100~240V AC
Primary power source input
connector
Operates on a single-phase
50/60Hz power source.
Provide secure grounding.
TB1,2,3
Connector for input/output
connection.
Refer to separate section for signal
details and precautions (PAGE 4-6).
Electric leakage breaker
When an electric leakage
occurs in the Unit, cable, or
tool, this breaker trip
instantaneously to secure
safety from the electric
leakage.
I…ON
O…OFF
TOOL
Connector for tool cable
connection.
Twist lock type connector.
Can be connected and
disconnected by twisting by 90
degrees.
Various FIELDBUS ports
The communication specification
can be selected from among
DeviceNet, PROFIBUS, CC-Link,
etc., in accordance with the user
specifications (PAGE 9-1~).
*RS232C-2
For ID data input
*Under development
*CF Card
Stores fastening result data and
curve data.
To Next Page
Loading...
