FEC HFC3000 - Page 69

Chapter 6 Description of Operations
PAGE 6-9
13
[Tool Response•G. Gyrosensor Shake Detection Angle]
-2048° ~ +2047°
Deg
14
[Tool Command•Ct1.] (0~255)
CAL ON, GYRO RESET, etc.
Digit
15
[Tool Command•Ct2.] (0~255)
Angle conversion constant (fixed at 67)
Digit
16
[Tool Command•LEd.] (0~255)
LED-related command
Digit
17
[Tool Command•BuZ.] (0~255)
Buzzer-related command
Digit
18
[Tool Command•Gan. Gyro Restriction Angle] (0~255)
Deg
19
[Fieldbus•Status Monitor•FbS]
Fieldbus connection condition: In the normal state, “4” is indicated.
Any other indication indicates an unconnected state (the STOP mode is entered
and operation is disabled).
20
[Angle Head Torque Variation [%]]
Displays the current torque variation rate of the angle head after the fastening
operation.
When the rate exceeds the value set in D-No.541“[Angle Head Torque Variation]”,
A.09-10 “Angle Head Torque Variation Abnormal” occurs.
%
D-No. 006: External I/O Disabling Function
(SW2: Pin No. 6 is ON)
D-No. 7: ZERO/CAL Voltage Error Warning
D-No. 006: Simplified I/O Monitor
(SW2: Pin No. 6 is OFF)
Lit up during forced output (all digits).
Standard DI (lit up if ON)
bit0 ... bit11
Standard DO (lit up if ON)
bit0 ... bit11
AUX. DI (lit up if ON)
Batch reset input signal