Chapter 6 Description of Operations
PAGE 6-13
6-2-5 Indications in the RUN Mode
In the system setting mode, “SYS.” is indicated in the WORK indication part.
The D-No. indication part is changed by pressing the [▲] or [▼] switch and the content corresponding
to No. is indicated accordingly. The value in the D-No. indication part can be skipped by 10 at a time
by long-pressing the [▲] or [▼] switch.
Please refer to the “List of Parameters” regarding the details of the set values.
“WORK” “COUNT/D-No.” “DATA”
Torque controller
Software Version
Amplifier Version
Touch panel
Port Number
To Next Page
Loading...
