Federal Signal Corporation SS2000+ ? Series User Manual

10
General Description
SS2000+ Series C
Federal Signal www.fedsig.com
• Two-Tone, MSK Packet Digital, EAS and DTMF encode
• FLASH/Programming Port
• Three programmable Relay Outputs
• I
2
C port for external relays or keyboard for additional activation buttons
• Status LEDs and LCD display
• Level Meter for Setting Receive Level
• Two Line Inputs for Transmission of External Audio Sources (3.5 mm)
• XLR Input for microphone, phantom power supply for amplified microphones
• High or Low Impedance for radio interface
• Carrier Detect from Radio/Transceiver or VOX with selectable polarity
• Monitor Speaker to monitor incoming and outgoing trac
• Powered from 12 to 30 Vdc, runs on standard 12 or 24 V backup power
• Oered in 120 and 240 Vac, with EU or UK versions available
Web Browser Activation
The SS2000+ has a built-in web interface that you can use to activate and configure
the SS2000+ from a standard Chrome
®
, Edge
®
, or Firefox
®
browser over you local-area
network (LAN). Digest Authentication is used for security.
CommanderOne
®
Cloud Service
You can configure the SS2000+ to connect to Federal Signal’s CommanderOne® cloud
service for automated activation from NOAA® EAS events. CommanderOne also enables
users to securely activate their SS2000+ devices from a web browser over the Internet.
Modbus Interface
The SS2000+ has a Modbus interface to easily interface with Industrial Control Systems.
Mobbus TCP is used to provide activations into an SS2000+ for specific warning
announcements across an industrial plant. You can activate the system using the
SS2000+ or industrial control systems can activate the hotkeys.
Encoding
Program up to three codes under each activation input. There are sixty programmable
functions available. These codes can be Two-Tone, Single-Tone, EAS, DTMF, Federal
Signal Digital Codes (FSK) and activating the three Relay Outputs, or calling another
activation key. Send each activation code from one to three times.
Modes of Operation
You can set the SS2000+ in either standalone or computer mode. In either mode, any
poll requests or activation commands from Commander Software, updates the clock in
the SS2000+ to match the Commander Software time and date. In computer mode, all
reports, status, and activations are logged within the Commander Software.
The SS2000+ can also receive streamed audio and encode activations from Commander
Software and transmit it out as audio.

Federal Signal Corporation SS2000+ ? Series Specifications

General

Brand	Federal Signal Corporation
Model	SS2000+ ? Series
Category	Controller
Language	English