33
Using the SSLoader+ Software
Description, Specications, SSLoader + Software, and Operation Manual
Federal Signal www.fedsig.com
Field Description
Com Port 1 Baud Rate Click the baud rate for com port number 1, which is the
Commander Software com port.
Com Port 2 Baud Rate Sends the baud rate for com port number 2, which is the
accessory com port.
Com 2 Function Click one of the following:
• None—Not used.
• Text Message—SS2000+ sends text messages from
Commander Software to an attached display sign.
• Printer Message—SS2000+ sends the messages that are
sent to the printer to a serial printer on Com Port 2.
• Control—Com 2 is used as a control port to Commander
Software.
• Radio Modem—SS2000+ sends and receives Federal
Signal Digital trafc over the radio interface and Com
Port 2.
General Parameters
The following shows the General Parameters group box of the General Configuration tab.
Field Description
AutoReport Delay Enter the number of seconds to wait after activating a function
before requesting a report. The range is 0 to 99 seconds.
Report Request Timeout Enter the number of seconds to wait for a response from a
Report Request before trying again or moving onto another
site. The range is 1 to 30 seconds.
Report Request Attempts Enter the number of times to attempt a request for a Report
from a site. The range is 1 to 3.
To Next Page
Loading...
Need help?
General
