Festo CTEU-EC - Replacing the I-Port Device - same Device Type (Substitute)

2. Commissioning
2-22
Festo P.BE-CTEU-EC-OP+MAINT-EN en 1208NH
2.2.2 Replacing the I-port device – same device type (substitute)
Procedure in auto mode
1. Switch off the bus node power supply.
2. Remove the bus node from the I-port device
(Dismantling/Mounting:  section 1.3).
3. Mount the bus node on the new I-port device
(Dismantling/Mounting:  section 1.3).
4. Switch the bus node power supply on again.
The bus node detects the connected I-port device.
In this case it is also possible to replace the I-port device
without switching off the bus node power supply.
Procedure in tool change mode
1. Do not switch off the bus node power supply.
2. Remove the bus node from the I-port device
(Dismantling/Mounting:  section 1.3).
3. Mount the bus node on the new I-port device
(Dismantling/Mounting:  section 1.3).
The bus node detects the connected I-port device.