Contents and general safety instructions
VIII
Festo P.BE-CTEU-EC-OP+MAINT-EN en 1208NH
Notesonthismanual
This manual is Part II of the product documentation for the
bus node, and contains specific information about the
configuration, parameterisation, commissioning, program-
ming and diagnosti cs of the bus node with the Eth erCAT
fieldbus protocol.
Information relating to installation of the bus node can be
found in Part I of the product documentation entitled
“Universal bus node CTEU-EC – Installation and Interface
manual”, which is supplied with the bus node.
All information rel ati ng to installati o n and to the interfaces
can also be found in chapter 1 of this manual.
Information on mounting the bus node on the electrical
connection box C APC-... can be found in the assembly
instructions that acco mpany the electrical connection box.
Information about other bus nodes and components of the
CTEU… product family can be found in the user
documentation for the respective product.
You can also find all documents online at:
www.festo.com Support portal: enter search term,
e.g. “CTEU” user documentation
To Next Page
Loading...
