Festo CTEU-EC - Replacing the Electrical Connection Box CAPC

2. Commissioning
2-24
Festo P.BE-CTEU-EC-OP+MAINT-EN en 1208NH
2.2.4 Replacing the electrical connection box CAPC-…
Procedure in auto mode
1. Switch off the bus node power supply.
2. Remove the bus node from the electrical connection bo x
(Dismantling/Mounting:  section 1.3).
3. Replace the electrical connecti o n box
For removal/installation of the electrical connection box,
follow the accompanying product documentation:
assembly instructions CAPC- F1-E - M12- D2
 www.festo.com  Suppor t por tal: enter search term,
e.g. “CAPC-F1-E-M12-D2”  User documentati o n.
4. Mount the bus node on the new electrical connection box
(Dismantling/Mounting:  section 1.3).
5. Switch the bus node power supply on again.
The bus node detects the connected I-port devices.