2. Commissioning
2-25
Festo P.BE-CTEU-EC-OP+MAINT-EN en 1208NH
Procedure in tool change mode
1. Switch off the bus node power supply.
2. Remove the bus node from the electrical connection bo x
(Dismantling/Mounting: section 1.3).
3. Replace the electrical connecti o n box
For removal/installation of the electrical connection box,
follow the accompanying product documentation:
assembly instructions CAPC- F1-E - M12- D2
www.festo.com Suppor t por tal: enter search term,
e.g. “CAPC-F1-E-M12-D2” User documentati o n.
4. Mount the bus node on the new electrical connection box
(Dismantling/Mounting: section 1.3).
5. Switch the bus node power supply on again.
The bus node detects the connected I-port devices.
To Next Page
Loading...
