Festo MPA Series - Page 150

5. Maintenance and conversion
5−18
Festo P.BE−MPA−EN en 0910d
Mounting Proceed as follows:
Caution
Replace an electronics module only by an electronics
module of the same type.
You can then avoid problems in controlling the solenoid
coils and damage to the electrical contacts.
Note
Before mounting, check the condition and position of the
following seals:
 The seals of the electronics module
 The ring seal of the electrical contacts
 The cord seal of the valves or blanking plates
1. Place the electronics module in the sub−base and fasten it
(tightening torque of the screws 0.4 Nm (±20%).
2. Then mount the valves or blanking plates
(seesectionMounting valves or blanking plates").