Festo MPA Series - Description of components

1. Summary of components
1−9
Festo P.BE−MPA−EN en 0910d
1.1.2 Description of components
The MPA−S valve terminal with CPX terminal or CPI module
consists of the following pneumatic components:
1
2
5
6
7
3
8
4
1 Only with MPA−S valve terminal with
CPX terminal:
Pressure sensor plate (optional)
2 Only with MPA−S valve terminal with
CPX terminal:
Proportional−pressure regulator or
blanking plate (optional)
3 Right end plate
4 Pneumatic supply plate (optional)
5 Inscription labels with support
(optional)
6 Sub−base with work connections and
serial linking (bus)
7 Electric supply plate (optional)
8 Seal (optional separating seal for
pressure zone separation)
Fig.1/5: Pneumatic components of the MPA−S valve terminal with CPX terminal or
CPImodule, 1st. level