Festo MPA Series - Fitting

2. Fitting
2−3
Festo P.BE−MPA−EN en 0910d
Contents of this chapter The MPA−S valve terminal is already assembled when
supplied from the factory. Accessories such as inscription
labels and manual override caps (optional) must be mounted
on site.
This chapter describes how to mount and remove:
 the complete MPA−S valve terminal
 the inscription label holders
 the manual override caps
Additional information special information on replacing or adding pneumatic
components can be found in chapter 5.
MPA−S valve terminal with CPX terminal:
 Information on mounting the MPA−S valve terminal with
CPX terminal can be found in the CPX system manual.
 Information on dismounting and mounting I/O modules is
provided in the I/O module description
(seethesystemdescription for your CPX terminal,
tableDescriptions of the CPX terminal").
 Information on mounting modules and components
ordered at a later stage can be found in the package
insert.