Contents and general instructions
VII
Festo P.BE−MPA−EN en 0910d
Intended use
The MPA−S valve terminals documented in this description are
intended for installation into a machine or automated system.
The user must at all times observe the safety regulations
specified in this manual as well as the instructions concerning
the designated use of the relevant MPA−S valve terminal.
TheMPA−S valve terminals may only be used as follows:
As intended in an industrial environment
In its original condition without unauthorised
modifications.
Only the conversions or modifications described in the
documentation accompanying the product are permitted.
In perfect technical condition.
When commercially available components, such as actuators,
are connected, the specified limits for pressures,
temperatures, electrical data, torques etc. must be
maintained. Comply with the regulations of the trade
associations and the German Technical Control Board (TÜV)
and the VDE conditions or corresponding national conditions.
Range of application and certifications
The product fulfils the requirements of the EU directives and
is marked with the CE certification.
Standards and test values which the product maintains and
fulfils can be found in the section Technical data."
Theproduct−relevant EU directivs can be found in the
declaration of conformity.
To Next Page
Loading...
