Festo MPA Series - Installation

3. Installation
3−3
Festo P.BE−MPA−EN en 0910d
Contents of this chapter This chapter describes the tubing and cabling of the MPA−S
valve terminal. This includes, in particular:
 General instructions on preparing the compressed air and
on connecting the tubing
 Instructions on pilot control with an internal or external
pilot air supply
 Instructions on operating the MPA−S valve terminal with
pressure zone separation
 Mounting the QS fittings
 Connecting the power supply
 Earthing the MPA−S valve terminal
 Address assignment of the valves
Further information Instructions on electrical connection of the MPA−S valve
terminal with multi−pin plug connection can be found in the
package insert.
Requirements for observing the UL certified conditions if the
product is operated in the USA or Canada can be found in the
separate special UL−specific documentation.
Instructions on connecting the operating voltage can be
found in the system description of your CPX terminal.
Detailed instructions on connecting the CPX modules
(busnodes, I/O modules etc.) can be found in the relevant
des cri pt i o n s for the CPX module (see the system description of
your CPX terminal, table Descriptions of the CPXterminal" ).
Detailed instructions on addressing the pneumatic modules
of the MPA−S valve terminal with CPX terminal can be found in
the MPA−... electronics description and the corresponding
description for your bus node (see system description for
your CPX terminal, table Descriptions of the CPX terminal").