A. Technical appendix
A−4
Festo P.BE−MPA−EN en 0910d
General information
Materials
Valve, sub−bases, supply plates and end plates
Electronics module
Multi−pin plug connection
Seals
Cover of the proportional pressure regulator
Al
POM/polycarbonate
Polyamide 6
elastomer, NBR
PAXMD6−GF50/gr−P; PA6−GB20, GF10/gr−P
Weights (in g):
Pneumatic interface or multiple connector plate
(with exhaust plate/flat plate silencer)
CPI sub−base (with exhaust plate / flat plate silencer)
AS interface (with exhaust plate / flat plate silencer)
Per sub−base (with seal, electronics module,
electrical interlinking, inscription label holder,
screws)
Per pneumatic supply plate (with seal, electrical
interlinking, screws, exhaust plate /
flatplatesilencer)
Per electrical air supply plate (with seal, electrical
interlinking, screws)
Per pressure sensor plate
Per proportional pressure regulator with sub−base
and electronicd module)
Per complete CPX module
Left−hand end plate (CPX terminal)
Right−hand end plate (MPA−S)
324 g/315 g
427 g/418 g
396 g / 360 g
185 g
120 g/111 g
200 g
200 g
approx. 575 g
approx. 210 g
approx. 80 g
55 g
MPA1 MPA2
per valve
Per cover plate
Per pressure regulator plate
approx. 56 g
24 g
100 g
approx. 100 g
44 g
180 g
Tab.A/1: General technical data
To Next Page