Change History
85
needed for the host product manufacturer to provide to end users in their end-product
manuals. If RF exposure statements and use conditions are not provided, then the host
product manufacturer is required to take responsibility of the module through a change in
FCC ID (new application).
Explanation: This module complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment, This equipment should be installed and operated with a minimum
distance of 20 centimeters between the radiator and your body." This module is designed to
comply with the FCC statement, FCC ID is: ZMOMG661LA
2.7 Antennas
A list of antennas included in the application for certification must be provided in the
instructions. For modular transmitters approved as limited modules, all applicable
professional installer instructions must be included as part of the information to the host
product manufacturer. The antenna list shall also identify the antenna types (monopole, PIFA,
dipole, antenna gain etc. (note that for example an “omni-directional antenna” is not
considered to be a specific “antenna type”)).
For situations where the host product manufacturer is responsible for an external connector,
for example with an RF pin and antenna trace design, the integration instructions shall inform
the installer that unique antenna connector must be used on the Part 15 authorized
transmitters used in the host product. The module manufacturers shall provide a list of
acceptable unique connectors.
Explanation: The EUT has a Rubber Duck Antenna, and allow maximum antenna gain as
below:
To Next Page
