Fimap FIMOP - PREPARING TO WORK

11
PREPARING TO WORK
Before beginning to work, it is necessary to:
ATTENTION: before beginning the rst work cycle, fully
recharge the battery (read “RECHARGING THE BATTERY”).
1. Before using the appliance, make sure it is in a good, safe
working condition. If everything is not in order, the appliance must
not be used.
2. Rotate the handlebar so it is vertical.
ATTENTION: during this operation, do not rest your foot on
the appliance.
3. Activate the appliance using the main switch (1) (Fig.1).
ATTENTION: if the LED of the main switch (1) (Fig.1) is lit up,
this means the electrical system of the appliance is activated.
4. Check the battery charge level. There are four LEDs (2) on the
battery to show the charge percentage (Fig.2). If all the LEDs are
lit up, the battery is fully charged; if they are all switched off, the
battery is completely run down.
5. Deactivate the appliance using the main switch (1) (Fig.3).
6. Remove the power battery (3) from the appliance. To free the
battery, shift the stop lever (4) in the direction of the arrow (Fig.4).
7. Remove the battery from the appliance using the handle moulded
on it (Fig.5).
8. Make sure the condition of the squeegee rubbers is suitable for
the work you want to carry out. If it isn't, perform the necessary
maintenance (read “MAINTENANCE”).
9. Make sure the condition of the brush is suitable for the work you
want to carry out. If it isn't, perform the necessary maintenance
(read “MAINTENANCE”).
10. Rotate the front carter (5) as far as it will go - do this with the aid
of the handle (6) (Fig.6).
ATTENTION: these operations must be carried out using
protective gloves to avoid any possible contact with the edges
or tips of metal objects.
11. Remove the solution tank from the device (Fig.7). Carefully place
it on the oor.
12. Remove the detergent solution lling cap (7) from its seat on the
solution tank (Fig.8).
13. Fill with clean water, at a temperature no higher than 50°C and
no lower than 10°C.
14. Add the liquid detergent to the solution tank in the concentration
and manner indicated on the detergent manufacturer's label.
ATTENTION: the formation of excess foam could damage the
vacuum motor, so use only the minimum amount of detergent
necessary.
ATTENTION: always use detergents whose manufacturer's
label indicates their suitability for scrubbing machines. Do not
use acid or alkaline products or solvents without this
indication. Acid or alkaline maintenance detergents can be
used, as long as they have pH values between four and ten,
and do not contain :oxidising agents, chlorine or bromine,
formaldehyde, mineral solvents.
ATTENTION: protective gloves should always be worn before
handling detergents or acidic or alkaline solutions, to avoid
serious injury to the hands.
ATTENTION: always use low-foam detergent. To avoid the
production of foam, put a minimum quantity of antifoam liquid
in the recovery tank before starting to clean. Do not use pure
acids.
15. Replace the detergent solution lling cap (7) in its seat on the
solution tank (Fig.9).
ATTENTION: it is good practice to empty the recovery tank
every time you top up the solution tank level.
16. Insert the solution tank in the device (Fig.10).
17. Rotate the front carter (5) as far as the work position - do this with
the aid of the handle (6) (Fig.11).
18. Insert the battery in the battery-holder compartment in the rear
part of the device.
6
5
7
6 87
11 2
31 2
OFFON
3
4
5
3