Fimap FIMOP - TROUBLESHOOTING

18
TROUBLESHOOTING
This chapter lists the most common problems linked with the use of the appliance. If you are unable to resolve the problems with the
information given here, please contact your nearest assistance centre.
PROBLEM POSSIBLE CAUSE SOLUTION
THE APPLIANCE DOES NOT SWITCH ON
The main switch is OFF. Press the main switch.
Check that the battery is correctly inserted
in the appliance.
Insert the battery correctly in the appliance.
Check the battery charge level.
If the battery charge level is critical, perform
a complete recharge cycle.
THE BATTERY HAS NOT BEEN
CHARGED CORRECTLY
The power supply cable plug is not correctly
inserted in the battery charger base socket.
Check that the plug on the battery charger
power cable is connected to the socket on
the battery charger base.
The power supply cable plug is not correctly
inserted in the mains socket.
Check that the battery charger power
supply cable plug is connected to the mains
socket.
The power supply network is not compatible
with the battery charger requirements.
Check that the features set out of the
battery charger information plate match
those of the power supply network.
The LED on the battery charger base
ashes repeatedly.
Referring to the battery charger use and
maintenance manual, check the meaning of
the ashing signals that the battery charger
emits during the battery recharge stage.
THE DEVICE HAS A VERY LOW
OPERATING AUTONOMY
Check the battery charge level and check
the symbol on the control display.
If the battery charge level is critical, perform
a complete recharge cycle.
NOT ENOUGH DETERGENT SOLUTION
ON THE BRUSH
The quantity of detergent solution in the
water system is not sufcient for the work
to be carried out.
Fill the solution tank with detergent.
Detergent solution lter blocked.
Remove the obstructions from the detergent
solution lter (read “MAINTENANCE”).
THE DEVICE DOES NOT CLEAN
CORRECTLY
The appliance does not switch on.
Read the section “THE APPLIANCE DOES
NOT SWITCH ON”.
The amount of detergent solution dispensed
is inadequate.
Read the section “NOT ENOUGH
DETERGENT SOLUTION ON THE
BRUSH”.
The brush is not correctly inserted in the
appliance.
Insert the brush correctly in the appliance.
The brush bristles are subject to excessive
wear
Check the condition of the brush,
and replace it if necessary (read
“MAINTENANCE”).
THE SQUEEGEE DOES NOT DRY
PERFECTLY
The vacuum device is obstructed
Remove the obstructions from the
squeegee (read “MAINTENANCE”).
Remove the obstructions from the vacuum
duct (read “MAINTENANCE”).
Remove the obstructions from the recovery
tank cover (read “MAINTENANCE”).
The recovery tank cover is not positioned
correctly.
Position the recovery tank cover correctly.
EXCESSIVE FOAM PRODUCTION
The detergent being used is not suitable.
Check that a low foam detergent has been
used. If necessary, add a small quantity of
antifoam liquid to the recovery tank.
The oor is not very dirty. Dilute the detergent inside the solution tank.