Fimap FIMOP - DISPOSAL; EC DECLARATION OF CONFORMITY

19
The undersigned manufacturer:
FIMAP S.p.A.
Via Invalidi del Lavoro, 1
37059 Santa Maria di Zevio (VR)
declares under its sole responsibility that the products
ELECTRIC BRUSH, "FIMOP" model
comply with the requirements of the following Directives:
• 2006/95/EC.
• 2004/108/EC
They also comply with the following standards:
• EN 55014 - 1: 2006 + A1: 2009
• EN 55014 - 2: 1997 + A2: 2008
• EN 60335 - 1
• EN 60335 - 2 - 72
• EN 60335 - 2 - 29
• EN 61000 - 3 - 2: 2006 + A2: 2009
• EN 61000 - 3 - 3: 2008
• EN 62233: 2008
EC DECLARATION OF CONFORMITY
The person authorised to compile the technical le:
Mr. Giancarlo Ruffo
Via Invalidi del Lavoro, 1
37059 Santa Maria di Zevio (VR) - ITALY
Santa Maria di Zevio, 09/02/2015
FIMAP S.p.A.
Legal representative
Giancarlo Ruffo
DISPOSAL
To dispose of the appliance, take it to a demolition centre or an
authorised collection centre.
Before scrapping the appliance, it is necessary to remove and
separate out the following materials, then send them to the
appropriate collection centres in accordance with applicable
environmental hygiene regulations:
• Brush
• Electric and electronic parts*
• Battery
• Plastic parts
• Metallic parts
(*) In particular, contact your distributor when scrapping electric and
electronic parts.
PROBLEM POSSIBLE CAUSE SOLUTION
THE DEVICE DOES NOT VACUUM
CORRECTLY
The recovery tank is full
Empty the recovery tank (read
“OVERFLOW DEVICE”).
The vacuum device is obstructed
Read the section "THE SQUEEGEE DOES
NOT DRY PERFECTLY".