User Guide • 23
2.8.2 Filling the Cup and Rinsing the Bowl
To fill the cup, press the −button briefly. The cup will be filled up to the pre-set level.
To rinse the bowl, press the −button briefly. The duration of the rinsing is pre-set. The
direction of the rinsing spray may be adjusted by rotating the nozzle of the faucet.
2.8.3 Water Heater (optional)
Heated water is often used with syringes and water injecting instruments. For that reason
the system can be delivered with a water heater. The temperature of the water is regulat-
ed with a thermostat. Overheating is prevented with a non-reversible thermal cut-out de-
vice. If the injected water is cold, please check the position of the button of the thermal
cut-out device. The release button is located on the right side of the water heater in the
bottom of the cuspidor.
2.8.4 Clean Water Bottle
Warning!
Use only bottles provided by Fimet Oy. Do not use bottles past their expiry dates.
Otherwise there is a possibility that the bottle breaks.
Clean water bottle
When the switch is turned on, the clean water bottle is pressurized to 1.5 bars and the wa-
ter for instruments is taken from the bottle. If the bottle is not in use, the water is taken
from the water main. The water for cup filling comes either from the clean water bottle or
from the water main depending on the desired type of setup.
switch on/off
To Next Page
Loading...