Fimet F1 - 2.8.5 Disinfecting the Water System; 2.8.6 Daily Use of Mild Disinfecting Solutions; 2.9 Connection Box; 2.9.1 Switching the Devices Power on and off

24 • User Guide
To add water, de-pressurize the bottle by turning the lever to the off-position. The bottle
can then be detached safely by rotating it counter clockwise. Do not overfill the bottle;
leave at least 2 cm free space on the top.
When starting to use the clean water bottle after main water line use, ensure the cleanli-
ness of the water hoses by allowing the water run for a couple of seconds through every
instrument, cup filling tap, and cuspidor bowl flushing tap.
2.8.5 Disinfecting the Water System
The clean water bottle can be used to disinfect the instrument hoses and the water tubing.
See section 3.1 Cleaning, Disinfecting for more information.
2.8.6 Daily Use of Mild Disinfecting Solutions
Mild disinfecting solutions can be used to prevent contamination coming from main water
line and build-up of microfilm. These liquids may be added to the clean water bottle in the
right proportion. Please read the manufacturer’s instructions for correct usage.
2.9 Connection Box
Warning!
The maximum connection voltage to the relays for the external devices is 24 V.
The Connection Box consists of a power supply and connections to drainage, air, mains
power, and main water line. The main fuse, the main power switch, and the relays for ex-
ternal devices are also in the connection box. Connection Box is connected to the unit
with flexible hoses and electric cables.
2.9.1 Switching the Device’s Power on and off
Warning!
There are harmful voltage levels, pressurized air, and water inside the connection
box. Only authorized maintenance staff may open the connection box.
Note!
When the device is switched on, there are pressurized air and water in the instrument
bridge, the suction head, the cuspidor, and the connection box.