Installation and Setup Guide
Chapter 3 - Getting Started28
To power up the blades one by one:
a Press the Console Select button so that the VGA screen attached to the chassis
displays output from the blade being powered up.
b Press the Power button until the power-up sequence is over. A log in prompt is
displayed.
c Repeat this procedure for each blade.
Figure 3-23: Blade
5.
Open your browser and enter https://10.0.0.1:3012. The Vital Security Set-up Console
login window appears. The Vital Security Set-up Console is a Web-based interface
that enables you to configure initial setup parameters associated with the box itself.
6. Log in to the Vital Security Set-up Console using admin as the username and finjan
as the password, and then click the Advanced Settings icon.
5.2 Initial Procedures for the Vital Security Scanning Server
The following initial procedure is the same for all the blades irrespective of the intended
network role (except for the Load Balancer).
To configure the Vital Security Scanning Server for setup:
1. Plug in the power cable and switch the appliance on.
2. Configure the network settings of any PC to match those of the appliance (IP address
and subnet mask).
IP address in the same subnet e.g. 10.0.0.101
Subnet mask 255.255.255.0
3. Connect your PC to one of the ports on the Gigabit Ethernet switch in I/O switch
module Bay 1 on the appliance using a network cable.
4. Power up the blades one by one:
To Next Page
Loading...
Need help?
General
