Installation and Setup Guide
27
Chapter 3 - Getting Started
8. Under the Scanning Server device, change the Log Server Interface IP to
127.0.0.1 if not already configured as such.
9. When you have defined all devices in the system or made any changes, click Apply
on the bottom right hand of the screen, and then click Commit Changes.
After defining your devices, Finjan recommends that you change the default password.
To change the default password:
1. Select the Settings tab on the Main Navigation bar.
2. From the System tab, select the Password tab. The Change Password dialog box
is displayed.
3. Enter your old and new passwords in the fields shown, and then click Apply.
5 Connecting your Vital Security Appliance NG-8000
The Vital Security Appliance NG-8000 is supplied as one or more separate blades. You
can assign system roles according to your requirements using each blade as a separate
server, or activate more than one service on a single blade.
Each Vital Security appliance is supplied with a default IP address, and can be remotely
accessed for initial setup by any PC in the same subnet. Vital Security uses a secure
(HTTPS) connection to a Web-based interface for remote access.
5.1 Initial Procedures for the Policy Server
The following initial procedure is the same for all the blades irrespective of the intended
network role (except for the Load Balancer).
To configure the Policy Server:
1. Plug in the power cable and switch the appliance on.
2. Configure the network settings of any PC to match those of the appliance (IP
address and subnet mask).
IP address in the same subnet e.g. 10.0.0.101
Subnet mask 255.255.255.0
3. Connect your PC to one of the ports on the Gigabit Ethernet switch in I/O switch
module Bay 1 on the appliance using a network cable.
4. Power up the blades one by one:
To Next Page
Loading...
Need help?
General
