Appendix B - Installation CD 79
A PPENDIX
I
NSTALLATION
CD
In order to install 8.4.0 and higher, the update can be performed using an Installation CD.
This effectively removes the need to perform Restore Factory Settings.
To install this Release using the Installation CD on NG-6000/NG-5000:
1. Attach a CD drive, or a bootable USB flash device and USB-keyboard and VGA
Monitor, to the appliance.
2. When the Finjan screen appears, type yes to continue with the process.
3. Let the installation run – it will take approximately 10 minutes. The Appliance
LCD will indicate that the Vital Security has not been installed yet.
4. Set up the configuration as required via the Setup Console
Initial Settings.
To install this Release using the Installation CD on NG-1000:
1. Attach a CD drive, or a bootable USB flash device and USB-keyboard and VGA
Monitor, to the appliance.
2. Check in the BIOS that it is set to Boot from CD/Flash Device using USB2.0.
a Navigate to Advanced BIOS features and press Enter.
b Using the arrow keys and the Page Up/Page Down keys, select the required
device to boot from (e.g., USB-CDROM).
c To change the USB to 2.0, navigate backwards using the Escape key and
select Integrated Peripherals.
d Select Enabled on the USB2.0 Controller.
3. Change the third boot device from HDD-1 to HDD-0.
4. Press F10 to exit and save configuration.
5. When the Finjan screen appears, type yes to continue with the process.
NOTE: Currently, the built-in CD-Rom device in the NG-6000 cannot be used.