16
RESETTING MAINTENANCE TIMER
The maintenance timer is operator
configurable and can be accessed
through the engine settings menu.
See “Reset MaintTimer” selection
in engine settings menu. When the
maintenance timer has expired, a
pop-up alert window indicating that
“Engine Maintenance is Due” will
be displayed. The operator must
acknowledge this pop-up to return
the control unit to normal display
operation.
To reset the maintenance timer
enter the Main Menu and then scroll
to the “Reset MaintTimer” entry using the “
” softkey. Press the “ ” softkey to select the reset
maintenance timer menu item.
Press the “
” softkey to reset the timer.
Acknowledge the timer was reset by pressing the Acknowledge “
” softkey.
Note: The maintenance hours data display will indicate 0 hrs when the timer has expired and the
operator has not yet reset the timer.
BACKLIGHT SETTING
The LCD backlight is adjustable
from 0 to 100%. To adjust the LCD
backlight enter the Main Menu and
navigate to the “Display Setup” menu
using the “
” softkey.
When highlighted enter the Display
Setup menu by selecting the “
”
softkey. Navigate through the
“Display Setup” menu using “
”
softkey until the “Backlight” entry is
highlighted.
Press the “
” softkey to select the backlight parameter setting.
Use the “
” / “ ” softkeys to set the backlight value.
To Next Page
Loading...
