31
STARTING PROCEDURE
See Safety Summary section of the manual before operating the
machine. Failure to comply could result in minor personal injury,
product damage, or property damage.
1. Verify that the rotary air valve cleanout / inspection doors are closed and secured in place.
2. Turn key clockwise to the RUN/ON (
) position and wait for key pad to illuminate and
go through its start-up procedure.
3. Press the engine start (ENG START) button on the key pad one time to turn on the fuel
pump. After fuel pump has started, press and hold the engine start (ENG START) button
until the engine starts.
The engine exhaust and some of its constituents are
known to cause cancer, birth defects, and other
reproductive harm. Wear protective equipment. To minimize exposure, avoid
breathing exhaust, do not idle the engine except as necessary, service your
vehicle in a well-ventilated area and wear gloves or wash your hands frequently
when servicing your vehicle. Breathing diesel engine exhaust exposes you to
chemicals known to cause cancer and birth defects or other reproductive harm.
Always start and operate the engine in a well-ventilated area.
If in an enclosed area, vent the exhaust to the outside.
Do not modify or tamper with the exhaust system.
Do not idle the engine except as necessary.
4. Allow the engine to warm up for 3 to 5 minutes.
5. Turn on the hydraulic system by flipping the toggle switch on the control box to the
HYDRAULICS ON position.
6. Activate remote by rotating the Emergency Stop
(e-stop) button clockwise to disengage e-stop
functionality. Press the green button located on
the back of the remote to turn on the unit.
NOTE: If the machine is running, the remote
should automatically pair.
To Next Page
Loading...
