27
STATIONARY REGENERATION BY ENGINE MANAGEMENT (CONTINUED)
If the Stationary Regeneration is delayed by pressing
the right soft key marked “NO” when the request is
displayed, a 15% power reduction is immediately applied
to the engine. A notification stating that “If no stationary
performed within 2 hours, Power Reduction is 50%” will
also be displayed. Once this message is acknowledged by
pressing the middle soft key on the display marked “
”,
the regeneration icon will be displayed and the
regeneration request will remain at the bottom of the
screen.
Note: Although not recommended, the engine can
be run in Stationary Standby mode (delaying
Stationary Regeneration) for a total of 10 hours.
For the first 2 hours, the engine power will be
reduced to 85%. For the remaining 8 hours, engine
power will be reduced to 50%. If the Stationary
Regeneration is not performed when requested
by the ECU, an excessive amount of PM will
accumulate. Abnormal combustion of PM may
cause damage to the DPF after extended operation
in Stationary Standby mode.
MANUAL STATIONARY REGENERATION - OPERATOR REQUEST
The operator has the option of performing a Manual Stationary Regeneration should work
conditions/schedule require. This is accomplished via the display [Main Menu “
”
Regeneration
“
”
Regeneration Start]. Manual Stationary Regeneration can only be completed after the engine
has accumulated 50 hours or more since its last regeneration.
1. Move the machine to a well-ventilated and safe location.
2. When the message “Bring Machine to Lo-idle Speed and confirm interlocks” is displayed,
make sure that the hydraulic switch on control box is in the REGEN INTERLOCK (down)
position. Reduce engine speed to low idle. Then acknowledge the message by pressing
the middle soft key on the display marked “
”.
3. When the message “Ready to begin Stationary Regeneration Now?” is displayed, press
the left soft key marked “YES”.
Note: Stationary Regeneration will not begin if any of the following conditions are present:
Coolant temperature is less than 60° C (140° F)
The engine has not been running for 15 minutes
An important DTC is active
If the hydraulic system is on
Idle speed is too high
If these conditions are present, a notification will be displayed. Once these conditions are
corrected by the operator, acknowledge the message and Stationary Regeneration will begin.
Engine can be run in Stationary
Standby Mode for 10 hours.
First 2 hours: 15% fuel cut
Next 8 hours: 50% fuel cut
To Next Page
Loading...
