OPERATING INSTRUCTIONS 17
False alarm
Reassembly
1. The Multisensor Plus Kitchen must be reassembled in
the kitchen.
2. Each Multisensor Plus must be reassembled in its origi-
nal room on the mounting plate. For better identication,
the serial number is printed or stuck on both the moun-
ting plate and the device.
3. Attach the device to the mounting plate and turn it clock-
wise (to the right) until it stops.
4. After reassembly, the device performs an automatic
function check. Please move away from the vicinity of
the Multisensor Plus within 10 seconds to avoid being
mistakenly detected as an “obstructing object,” which
could cause the Multisensor Plus to signal a fault.
CAUTION
The CO alarm is usually not a false alarm and
should therefore always be taken seriously.
If you cannot detect any smoke or re source, it could
be the colorless and odorless gas carbon monoxide (CO).
Please check the type of alert (sound and light signal
(LED)) on the device, open windows and doors, and iden-
tify the source of the alarm, if it is safe to do so.
More information on CO can be found in the section „Car-
bon Monoxide (CO) - Important Guidelines.“
It may happen that the Multisensor Plus detects smoke or
heat even though no smoke or re is visible.
An alarm should still be taken seriously in every case. If
you cannot determine a cause for the alarm, deactivate the
alarm by pressing the user button briey once.
To Next Page
Loading...
