OPERATING INSTRUCTIONS 9
-
In the event of an alarm, an assistance light is activated to aid
orientation. Should there be uncertainty about the origin of an
alarm, it is prudent to treat it as a genuine re and/or elevated
CO levels. Upon detection of smoke, heat, or CO, the alarm
can be temporarily silenced for approximately 15 minutes; by
pressing the user button the red LED will continue to ash.
If the presence of smoke, heat, or CO persists, the alarm will
reactivate.
CAUTION
Do not use perfumes, air fresheners, hair sprays,
paint sprays, or other aerosol products near the
Multisensor Plus.
The smoke, heat, and carbon monoxide detection sensors are
only active when the Multisensor Plus is mounted on the ins-
tallation plate. This means that a removed (demounted) device
cannot warn of these hazards.
Grouping
Up to ten Multisensor Plus devices can be networked toge-
ther. This setting is congured during installation and can only
be changed by reactivating the devices by service personnel.
Grouping all detectors in an apartment ensures that in the
event of an alarm, all detectors will signal acoustically. Howe-
ver, only the Multisensor Plus that detected the smoke, heat,
or CO will blink with the red LED.
To silence the alarm tone, the user button on the device can
be pressed. If the button is pressed on the detector that de-
tected the alarm condition, the alarm tones of the other net-
worked devices will also be silenced after a short delay. If the
button is pressed on a device that did not detect the alarm,
all devices will be No soundd except the one that detected
the alarm. The functionality of the grouping may be limited or
unavailable in certain structural conditions (for example, with
thick walls).
To Next Page
Loading...
