EasyManua.ls Logo

FireClass FC506 - Page 17

Default Icon
88 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Table 5: Description of the status LEDs.
LED Description
SOUNDERS
SILENCED
(Amber)
ON indicates that the
silenceable outputs and loop
device have been forced
into standby by means of
the SILENCE/ RESOUND
SOUNDERS key. In day mode,
the silence status remains
until the SILENCE/RESOUND
SOUNDER key is pressed again.
In night mode, the silence
status remains until the night
mode silence time expires
or until the system detects a
new alarm or a new trouble
condition.
FIRE
SIGNAL
ON
(Red)
ON indicates that the
transmission was successful.
Blinking indicates that the
transmission is in progress.
On the control panel screen,
the connection type, such as
PSTN, GSM, or LAN network, is
displayed.
SOUNDERS
FAULTS/
DIS
(Amber)
ON indicates that the output is
disabled or outputs configured
to "act as SC1" are disabled.
Blinking indicates that the SC1
is in fault or outputs configured
to "act as SC1" are in fault.
OFF indicates that all the main
sounder outputs (EN54-1, TYPE
"C" outputs) function properly.
DISABLED
(Amber)
ON indicates the disabled
status of any bypassable entity.
TEST
(Amber)
ON indicates the test
conditions on at least one zone.
Table 5: Description of the status LEDs.
LED Description
DAY MODE
(Amber)
ON indicates that the control
panel is operating in day mode.
OFF indicates that the control
panel is operating in night
mode.
1-8 SOFTWARE
ZONES
(Red)
ON indicates that the
corresponding software zones
are in Alarm status *.
Note: * indicates that
the zone outside the 1-
8 range does not have
a related LED, its alarm
status is displayed only by
the LCD.
Blinking indicates that the
corresponding software zones
are in Delay to Alarm status.
CONTROLS
ON
(Amber)
ON indicates that the control
panel is at least at level 2
so the SILENCE/RESOUND
SOUNDERS, RESET and
INVESTIGATION DELAY keys
are enabled.
Note: * the zone outside the 1 to 8 range
does not have a related LED, its alarm status is
displayed only by the LCD, ** buzzer SYSTEM
FAULT pattern, *** buzzer FAULT pattern.
FC503 and FC506 Addressable Fire Control Panels 17
Johnson Controls - CONFIDENTIAL

Table of Contents

Other manuals for FireClass FC506

Related product manuals